Cleaning your machine, Removing face plate, Removing face plate cleaning the machine – SINGER 2210 Athena User Manual
Page 47: Edge
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5. CLEANING YOUR MACHINE
To ensure reliability, regularly clean and lubricate machine. Periodic check-ups
by an authorized service center are recommended depending upon frequency of
Removing Face Plate
Cleaning the Machine
CAUTION: Before attempting any procedures
in this chapter, disconnect power!Ine plug
from electrical outlet!
Only remove the face plate of the machine
for cleaning, lubricating, and light bulb
replacement. Keep securely fastened at all
« Loosen and remove screw (1).
♦ Remove face plate by drawing it slightly
towards the operator and to the left (2),
• Replace face plate by sliding it to the right
of arm top cover (3).
« When snugly seated, replace and tighten
^ For normal external cleaning, use a soft
dry cloth. Stubborn stains may be re
moved with a mild soap and v^ater solu
♦ Using a soft brush, remove all lint froin
exposed mechanical parts under face
plate as well as thread path and needle,
feed, and bobbin areas.
* Periodically, apply a drop of oil to areas
shown. DO NOT over oil!