Vortech 2005-2010 Ford 4.6L 3v Mustang GT - Manual (Page 27)

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
5
A. Locate the factory oil sensor on the driver’s side
of the vehicle near the oil filter.
B. Remove the sending unit and set aside.
C. Locate the supplied 1/4"NPT street TEE fitting.
Install the TEE in the same location as the factory
sending unit with the 1/4" x –4 x 90° installed on
the TEE at the location noted. (See Fig. 2-a.)
D. Attach the stainless steel –4 hose to the –4 fitting
installed in the street TEE. (See Fig. 2-a.)
E. Route the hose away from hot, sharp or moving
parts and move to the top of the engine where it
will be attached to the supercharger oil feed.
F. Reinstall the factory sensor in the branch of the
TEE as shown. (See Fig. 2-a.)
Fig. 2-a
NOTE: The oil feed hose to the S/C will
be installed in a later step of the
installation. Temporarily cap the
open end of the hose to prevent
contamination to the inside of the
hose.
2. OIL FEED INSTALLATION (Engine oil-fed kits only. Applications with V-3
superchargers skip ahead to step 4.)