Vortech 2005-2010 Ford 4.6L 3v Mustang GT - Manual (Page 36)

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
14
A. Unplug the cam sensor connector.
B. Tensioner modification (skip to step c. if installing
belt tensioner assist):
1. Remove the three screws retaining the factory
spring tensioner to the front of the engine.
Remove the factory steel idler from the ten-
sioner and replace with the supplied 3" idler
(4FU116-031) using the factory hardware.
(See Fig. 6.1-a.)
2. Install the three M8 x 40mm bolts w/washers
through the tensioner mounting holes.
3. Slide the three .75"OD x .328"ID x .140" spac-
ers onto the three bolts protruding through the
tensioner. (See Fig. 6.1-a.)
4. Secure the tensioner assembly to the front of
the engine. Use Fig. 6.1-a as guide for spacer
placement.
6.1 PULLEY AND SPACER REPLACEMENT (Bullitt/V-Power/8-Rib Kits Only - All
others skip to step 6.2)
Fig. 6.1-a