Vortech 2005-2010 Ford 4.6L 3v Mustang GT - Manual (Page 78)

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
56
Fig. 14-g
L. Slide the supplied 11.3 stepless clamps onto the
two open legs of the Y-fitting. Connect the dis-
charge of both pumps to the previously installed
“Y” fitting using the two supplied Ø3/8" corrugated
teflon hoses. Secure the remaining hose ends
using the supplied 11.3 stepless clamps. (See
Fig. 14-h.)
M. Secure all hoses to the fuel pump assembly using
the supplied ties. Make sure the lid is able to
spring up and down without restriction and that
the hoses do not kink. (See Fig.
14-h.)
N. Use the supplied T-splice and slide connectors to
connect the black and red wires from the supplied
pump to the corresponding power and ground on
the factory pump. (See Fig. 14-h.)
O. Reinstall the fuel pump assembly into the fuel
tank in the reverse order of removal. Ensure that
the fuel hoses do not rub on the sharp edges of
the fuel tank. Take care not to damage the assem-
bly. INSTALLATION WILL BE TIGHT. Connect all
fuel and electrical connections. Verify that the fuel
gauge float is able to move freely. Make sure the
O-ring seal is in place and not damaged. There is
an alignment arrow on the pump assembly top
that will need to be aligned with the dot on the fuel
tank. (See Fig. 14-b.)
Fig. 14-h
HOSE FROM
SUPPLIED
PUMP
P. Locate the power distribution box located on the
passenger’s side of the engine compartment.
Verify the #41 fuse is for the fuel pump.(2010
Model year uses #13) Replace the factory
15AMP fuse with the supplied 20AMP fuse.
Q. Cycle the ignition key and check for any fuel
leaks, verify proper fuel gauge operation.
R. Reinstall the plastic inspection cover and rear
seat.
NOTE: Retaining ring indents must engage
their receivers for proper seal. (See
Fig. 14-b.)
14. FUEL PUMP UPGRADE, cont’d
SUPPLIED
.75" LONG
TEFLON
SLEEVES
POWER AND
GROUND
CONNECTIONS
HOSE FROM
FACTORY PUMP