Vortech 2005-2010 Ford 4.6L 3v Mustang GT User Manual
Page 39
P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
17
5.
Locate the remaining 3.5" smooth idler (4FU017-031),
.544" long pilot spacer, and 1.597" long spacer as
depicted in Fig. 6.1-d.
6.
Install the idler pulley assembly referencing Figs. 6.1-d,
6.2-a.
K.
S/C mounting plate installation:
1.
Install the two 140mm bolts into their mounting plate
hole locations and slide the two 2.691" long spacers
onto them. (See Figs. 6.1-d,
6.2-a.)
2.
Install the idler plate onto the previously installed hard-
ware and spacers.
3.
Install the .097" long spacer onto the bolt that will be
secured through the alternator. (See Figs. 6.1-d, 6.2-a.)
4.
Loosely install the S/C mounting plate assembly using
the original S/C mounting plate hardware, taking care to
route the drive belt on the correct side of the spacers.
(See Figs. 6.2-b, 6.2-c.)
NOTE: See Fig. 6.1-d for the next few steps.
Fig. 6.1-d
6.1 PULLEY AND SPACER REPLACEMENT (Bullitt/V-Power/8-Rib kits Only - All
others skip to step 6.2), cont'd