Vortech 2005-2010 Ford 4.6L 3v Mustang GT - Manual (Page 77)

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
55
H. Using the supplied 17.0 stepless clamps and
2.75" length of Ø3/8" rubber hose, connect the
supplied “Y” fitting to the distribution rail. (See
Fig. 14-e.)
I. Locate the supplied fuel pump and pump inlet
screen. Attach the pump inlet screen to the pump
and orient exactly as shown. (See Fig. 14-f.)
J. Secure the supplied fuel pump to the side of the
factory pump assembly using the #44 hose clamp
supplied. Verify that the hose clamp is routed
inside of the metal posts so that they can be
pushed down without restriction. (See Fig. 14-f.)
K. Slide the two supplied .75" long teflon sleeves
over the discharge of each fuel pump. (See Fig.
14-g.)
Fig. 14-e
Fig. 14-f
PUMP INLET
SCREEN
#44 HOSE
CLAMP
NOTE: The supplied 1.5" long Teflon tube
will need to be cut into two .75" long
pieces.
14. FUEL PUMP UPGRADE, cont’d
Y-FITTING