Vortech 2005-2010 Ford 4.6L 3v Mustang GT - Manual (Page 61)

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
39
Fig. 8E-d
Fig. 8E-e
10mm HEADED
BOLT
Fig. 8E-f
3/4" HOSE ATTACHED
TO FACTORY 1" HOSE
Fig. 8E-g
8. CHARGE AIR COOLER INSTALLATION (
CHARGE COOLED KITS ONLY
), cont’d
5. Remove the 10mm headed bolt that secures
the back of the ECU and the power distribu-
tion box. (See Fig. 8E-d.)
6. Install the coolant reservoir. Secure the front
of the reservoir with the factory fastener
removed previously. (See Fig.
8E-e.)
7.1 Attach the rear mounting bracket with the
surge tank mounting bracket to the strut tower
using the factory strut mounting hardware.
(See Fig. 8E-f.)
7.2 (Bullitt Only) Attach bracket 4FU010-061 on
the underside of the 4FU010-091 reservoir
bracket to ensure clearance from strut tower
brace.
8. Attach a length of 3/4" hose (approximately
22" long) to the 3/4" bung on the front of the
coolant reservoir. Secure using one of the #10
hose clamps provided. Route the open end of
the hose to the 1" hose previously connected
to the factory coolant reservoir. Connect and
secure the two hoses using the 3/4" x 1" hose
union, the factory 1" spring clamp and the #10
hose clamp provided.
NOTE: Leave this bolt loose for final adjustment in a
later step.
E. ENGINE COOLANT RESERVOIR
INSTALLATION (2007-2010 Models Only),
cont’d
SURGE TANK
RESERVOIR
BRACKET
COOLANT
RESERVOIR
RESERVOIR
BRACKET