Vortech 2005-2010 Ford 4.6L 3v Mustang GT User Manual

Page 38

Advertising
background image

P/N: 4FU020-010 v6.2, 06-08-10

©2010 Vortech Engineering, LLC

All Rights Reserved, Intl. Corp. Secured

16

F.

Remove the two bolts that retain the factory

idlers to the front cover. Discard the idlers and

bolts. Replace the top idler with the 3.5"

smooth idler (4FU016-021) .875"OD x .663"ID

x .101" spacer and stud bolt provided. Replace

the lower idler with the 3.5" ribbed idler

(4FU016-041) .875"OD x .663"ID x .101" spac-

er and stud bolt provided. (See Fig. 6.1-c.)

G.

Using the appropriate pulley puller, remove the

factory power steering pulley and discard.

Replace with the supplied 8-rib power steering

pulley with the appropriate installer tool.

H.

Remove the A/C clutch retaining screws.

Carefully remove the clutch and set aside with

the hardware and small spacer located

between tip of A/C compressor drive shaft and

A/C clutch spline. Replace with the supplied

8-rib A/C pulley (4FR016-021), and secure

using the factory hardware and spacer.

I.

Remove the crank pulley retaining bolt.

Using the appropriate pulley puller,

remove the crank pulley and discard.

Install the supplied 8-rib crank pulley

using the factory retaining bolt. (Thread

locking compound must be applied to the

screw threads.)

J.

Loosely install the 8-rib drive belt provid-

ed using Fig. 6.1-c for belt route refer-

ence. Not all pulleys are installed at this

time.

6.1 PULLEY AND SPACER REPLACEMENT (Bullitt/V-Power/8-Rib Kits Only - All

others skip to step 6.2), cont'd

Fig. 6.1-c

Advertising