Charge air cooler installation, Cont’d, Front of vehicle – Vortech 2005-2010 Ford 4.6L 3v Mustang GT User Manual

Page 52

Advertising
background image

P/N: 4FU020-010 v6.2, 06-08-10

©2010 Vortech Engineering, LLC

All Rights Reserved, Intl. Corp. Secured

30

8. CHARGE AIR COOLER INSTALLATION

(CHARGE COOLED KITS ONLY)

, cont’d

Fig. 8B-j | Viewed From Below

17. Locate the 3/4" x 150° molded rubber hose

(7U038-150). Connect the short end of the

3/4" x 150° hose to the lower port on the pre-

viously installed water cooler. Install one of

the provided 3/4" hose unions into the open

end of the 150° hose. Attach a length of 3/4"

hose approximately 24" between tthe hose

union and the previously installed water pump

discharge. Secure all hose connections using

the nylon ratchet clamps provided. (See Fig.

8B-j.)

2010 models will require the passenger side

air diverter to be trimmed where the power

steering cooler line passes through. Enlarge

the bottom of this notch 1-1/2˝ for 3/4˝ hose to

pass through

18. Attach a length of 3/4" hose approximatelly

48" long to the previously installed water

pump feed port and secure. Route the open

end of the installed hose toward the passen-

ger’s side shock tower. This hose will be

connnected in later step. (See Fig. 8B-h.)

WATER COOLER

HOSE TO

WATER

PUMP

3/4" x 150°

HOSE (7U038-

150)

3/4" HOSE

UNION

FRONT OF VEHICLE

B.

WATER COOLER ASSEMBLY INSTALLATION, cont’d

NOTE: The installation of this hose sec-

tion should maintain an “uphill”

routing wthout dips or kinks.

Advertising