Vortech 2005-2010 Ford 4.6L 3v Mustang GT - Manual (Page 66)

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
44
H. BUMPER COVER MODIFICATION (2010
MODELS ONLY) con'td
4.. Trial fit bumper and check for interference
against intercooler. Additional removal of mate
rial may be required to clear the intercooler
end tanks and brackets (See Fig 8H-d,e).
5. Remove bumper and mark on upper lip sup-
ports 1” from edge. Drill a 1/4 “ hole from the
top of the support through the lip of the grill.
From the bottom drill a 5/16” hole through the
lip only, being careful not to drill through the
support. An angle drill using the shortest bit
possible is recommended.
5. Install the supplied 1/4-20 Nylon shouldered
bolts from the lip side so that the threads pro
trude through the supports and attach with the
supplied 1-4/20 Nylock nut (See Fig. 8H-f). Do
not over tighten nuts.
6. Reinstall the front bumper assembly including
the foam inner bumper, all plastic splash pan-
els and light connections in the reverse order
removed. See Fig. 8H-g for final installation
reference.
Fig. 8H-d
Fig. 8H-e
Fig. 8H-f Fig. 8H-g
8. CHARGE AIR COOLER INSTALLATION (CHARGE COOLED KITS ONLY), cont’d