Vortech 2005-2010 Ford 4.6L 3v Mustang GT - Manual (Page 79)

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
57
Fig. 15-a
15. REFLASH COMPUTER
A. Reconnect the battery.
B. Locate the vehicle’s OBD2 connector located in the
lower left hand corner of the dash on the driver’s
side of the vehicle. (See Fig 15-a.)
C. Attach the OBD2 connector from the Flash tool
(provided in the kit) to the vehicle’s OBD2 port.
(See Fig 15-b.) Make sure this connector is seat-
ed all the way into the vehicle’s OBD2 port. You
do not want this connector coming out during pro-
gramming or damage may occur to the vehicle’s
ECM.
D. The Reflash tool should power up and display
three parameters:
1. Performance Tune
2. Diagnostics
3. Options
E. Select “Performance Tune” and press the enter
button in the middle of the arrow keys. (See Fig
15-c.)
F. Read the disclaimer entirely, then select agree
and press ENTER.
G. At this point please read the screen displayed on
the reflash tool. If you have any questions, either
refer to the manual provided with the reflash tool
or contact our service department for further
assistance.
H. Turn the ignition on (do not start the vehicle). Set
the parking brake and press the “ENTER” button
to continue.
I. “SELECT TUNE” will be displayed at the top of
the screen. Use the arrow keys to select the
appropriate tune for your vehicle and press the
ENTER button. You will have four choices to
select from:
1. STD OUTPUT (non charge-cooled)
2. Charge-cooled, air/water
3. Charge-cooled, air/air (this option is NOT
used in this application)
4. Original Backup
J. Continue to follow the screen and when finished
unplug the reflash tool from the vehicles OBD2
port.
IMPORTANT! To ensure trouble-free programming of your vehicle's computer:
• Make sure the vehicle's battery is sufficiently charged.
• Turn off all accessories and close doors to prevent unnecessary drain on the battery.
• Do not attempt to program your vehicle while a battery charger is connected.
• Improper battery voltage will result in failure of the programming process.
• Do not disconnect the cable or turn off the ignition during programming.
NOTE: Do not disturb the cable, or turn the
ignition off during this time. If the
programming is disrupted, the com-
puter will not start or run your vehi-
cle!
Fig. 15-b
Fig. 15-c
ESCAPE
ENTER
OR
SELECT
ARROWKEYS