Vortech 2005-2010 Ford 4.6L 3v Mustang GT - Manual (Page 70)

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
48
10. COMPRESSOR BY-PASS VALVE INSTALLATION (Non-cooled kits only)
A. Assemble the compressor by-pass valve by using
a piece of 1" hose cut 15" long and a piece cut to
4.25" long, and four #16 hose clamps.
B. Attach the 4.25" piece of hose to the inlet of the
bypass and secure with a #16 clamp.
C. Secure the 15" piece to the by-pass valve outlet
using a #16 hose clamp. (See Fig.
10-a.)
D. Attach the open end of the 4.25" hose to the boss
on the air discharge duct. Secure with a #16 hose
clamp. The open end of the 15" long hose will be
connected to the air inlet in a future step.
E. Secure all hoses with the clamps provided.
F. Connect the supplied length of 5/32" vacuum to
the port on the bypass valve. Route the line to the
fuel regulator vacuum hose. Using the supplied
vacuum TEE, connect the bypass vacuum line.
(See Figs. 10-a, 10-b, for assistance.)
Fig. 10-b
FUEL REGULATOR SUPPLIED
VACUUM
TEE
Fig. 10-a
4.25" x 1" HOSE Ø
(TRIM TO FIT)
TO DISCHARGE
TUBE
15" x 1" HOS E Ø
(TRIM TO FIT)
TO MANIFOLD PRESSURE/VACUUM
#16 HOSE CLAMPS
BYPASS
VALV E
TO INLET
DUCT