Vortech 2005-2010 Ford 4.6L 3v Mustang GT User Manual
Page 74
P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
52
L.
Install the MAF sensor and air filter to
the 180° duct. (See Fig. 13-h.)
M.
Install the 180° duct and the MAF sen-
sor with filter to the inlet duct leading
to the Supercharger. (See Fig. 13-i.)
Clock the MAF exactly as shown.
(See Fig. 13-i.)
N.
Secure the rear clamp at the inlet duct
union to the previously installed sup-
port bracket. (See Fig. 13-i.)
O.
MAF (Mass Air Meter) (Non-Cooled
Kits Only) Harness Extension:
1.
Locate the supplied wire and butt
connectors in assembly 4FU101-
001.
NOTE: Install the MAF sensor element so
the inlet of the sensor faces the air
filter. (See Fig. 10-h.)
13. AIR INLET ASSEMBLY, cont’d
F.
Attach the 3/8" hose previously connected to the
passenger’s side valve cover, to the 1/4"NPT x
3/8" hose x 90° fitting installed in a previous step.
G.
Attach the 1" bypass outlet hose to the 90° plastic
fitting and secure the hose with a #16 hose clamp.
H.
Install the duct to the inlet of the supercharger and
secure in place with the clamps provided.
I.
Locate and install a 4.0" x 2.0" long sleeve to the
inlet of duct 4FU012-010 and secure with two #64
clamps. (See Fig. 13-e.)
J.
Remove the Factory MAF sensor element from
the top portion of the air filter housing.
K.
Install the element using the 4mm hardware pro-
vided to the supplied MAF tube. (See Figs. 13-f,
13-g.)
Fig. 13-e
Fig. 13-f
Fig. 13-g
TO MAF
FACING
AIR
FILTER