Vortech 2005-2010 Ford 4.6L 3v Mustang GT - Manual (Page 57)

P/N: 4FU020-010 v6.2, 06-08-10
©2010 Vortech Engineering, LLC
All Rights Reserved, Intl. Corp. Secured
35
Fig. 8C-d
Fig. 8C-e
RESERVOIR
BRACKET
Fig. 8C-f
FACTORY
GROUND STRAP
Fig. 8C-g
8. CHARGE AIR COOLER INSTALLATION ( CHARGE COOLED KITS ONLY ), cont’d
NOTE: Reinstall the factory ground wire
with one of the 6mm screws and
washers.
5. Remove the 10mm headed bolt that secures
the back of the ECU and the power distribu-
tion box. (See Fig. 8C-d.)
6. Install the coolant reservoir. Secure the front
of the reservoir with the factory fastener
removed previously. (See Fig.
8C-e.)
7. Attach the rear mounting bracket with the
surge tank mounting bracket to the strut tower
with the 6mm x 20mm long screws and wash-
er provided. (See Fig. 8C-f.)
NOTE: Leave this bolt loose for final
adjustment in a later step.
8. Attach a length of 3/4" hose (approximately 3'
long) to the 3/4" bung on the front of the cool-
ant reservoir. Route the hose to the 3/4" outlet
on the thermostat housing secure the hose
with the clamps provided. (See Fig. 8C-g.)
C. ENGINE COOLANT RESERVOIR
INSTALLATION (2005-2006 Models Only),
cont’d
10mm
HEADED
BOLT
3/4" HOSE ATTACHED
TO THERMOSTAT HOUSING
NOTE: A/C line on the passenger side
must be bent away from block
for reservoir clearance. This can
be done with a large screwdriver
as depicted in figure 8C-g2.
Fig. 8C-g2