CIRCUTOR AFQ Series - Manual (Page 83)

AFQ-4W
Instruction Manual 83
The controller software update is complete.
If the display software is not updated, update this software before
starting up the unit. (Section 6.2)
When the controller software update is complete, it may be necessary
to reconfigure the unit parameters. Before starting up the AFQ-4W
following an update, check all of the configuration
parameters.(Section 4.3.)
6.2. DISPLAY SOFTWARE UPDATE.
To update the panel software:
 a USB memory stick
 the update file Vx.yx_CIRCUTOR. ( x.yz: software version number)
Follow the steps below to update the display software:
1.- Copy the file XP_Project in the root directory of the memory stick.
Omit this step if you have a CIRCUTOR memory stick
If the XP_Project file is compressed in a *.rar format, unzip the file and copy it to
the memory stick in the directory:
(USB memory root):\XP_Project\Vx.yz_CIRCUTOR
2.- Place the AFQ-4W in STOP mode and turn off the main switch
(OFF position).
3.- Wait 5 minutes for the energy accumulated in the capacitors to discharge.
4.- With the unit turned off, open the front door and plug the memory stick into
the USB port located behind the screen. ( Figure 95 )