d&b T-Series - Manual (Page 13)

Splay / Rear links
T10
The Splay links of the T10 cabinets are fold out and hooked into the
preset Locking pin on the rear rigging strand of the next cabinet.
Once the Splay link is hooked in, the second Locking pin must be
inserted. The second Locking pin acts as a "safety pin" to secure the
Splay link from possible hooking off and to fix the set splay angle.
T-SUB
The Rear link of the T-SUB cabinets are fit into the rear rigging strand of
the next cabinet and fixed in position with the Locking pin of the Rear
link.
Once the Rear link is fit into the rear rigging strand of the next cabinet
the Rear link is fixed in place using the two Locking pins of the next
cabinet.
2.5. E7451/53 Touring cases
E7451 Touring case 4 x T10 assembly
The E7451 Touring case is intended to store and transport 4 x T10
cabinets which are interconnected by their Front links. It also allows you
to connect the assembly to the Flying frame or below T-SUBs within a
mixed T-SUB/T10 array in one procedure.
The assembly instructions are given in section 4.1.4 Setup of the E7451
Touring case assembly starting from page 27.
E7453 Touring case 2 x T-SUB assembly
The E7453 Touring case is intended to store and transport 2 x T-SUB
cabinets. If the two T-SUB cabinets are interconnected by their Front
and Rear links it also allows you to connect the assembly to the Flying
frame in one procedure to build T-SUB columns or mixed T-SUB/T10
arrays.
The assembly follows the instructions given in section 4.1.2 T-SUB
Column starting from page 23.
T-Series Rigging manual (1.1 EN) Page 13 of 44