d&b T-Series - Manual (Page 41)

7. Care and maintenance / Disposal
7.1. Transport / Storing
During transport ensure the rigging components are not stressed or
damaged by mechanical forces. Use suitable transport cases.
The surface treatment temporarily protects the rigging components
against moisture. However, ensure the components are in a dry state
when storing and transporting them.
7.2. Visual and functional inspection
Cabinet enclosure
- Visual inspection of all fitting plates for obvious damage (e.g. cracks
or corrosion).
- Inspection of all fitting plates including the front grills to ensure they
are securely attached.
Locking pins
- Visual inspection for deformation of the component.
- Inspection for missing ball bearings and damage.
- Functional inspection of the release mechanism to ensure it operates
properly.
- Regularly lubricate the Locking pins using WD-40 ® or a similar
product.
Front and Splay (Rear) links
Visual inspection for deformation and damage (e.g. cracks and
corrosion) including all holes of the component.
Flying frame
- Visual inspection regarding deformation and damage (e.g. cracks
and corrosion) including all holes of the component.
- Regularly check the flatness of the Flying frame. For this purpose
place the Flying frame on a flat surface and visually check the frame
for deformation and/or torsion. In case obvious deformation and/or
torsion contact d&b audiotechnik for further advice.
Load adapter
- Visual inspection for deformation and damage (e.g. cracks and
corrosion) including all holes of the component.
7.3. Disposal
Please dispose of this product according to the respective national
regulations.
Ensure that damaged rigging components are disposed of so that they
cannot be used again.
T-Series Rigging manual (1.1 EN) Page 41 of 44