d&b T-Series - Manual (Page 4)

1. Safety precautions
1.1. Intended use
The T-Series rigging components (Flying frame, Load adapter, Locking
pins) must only be used in conjunction with d&b T-Series loudspeakers
as described in this manual.
Installation and setup should only be carried out by qualified and
authorized personnel observing the valid national Rules for the
Prevention of Accidents (RPA).
It is the responsibility of the person installing the assembly to ensure that
the suspension/fixing points are suitable for the intended use.
1.1.1. Load capacity/System safety
The Z5370 T Flying frame is designed to suspend a total
system weight of 250 kg (550 lb) – SWL.
The rigging components allow arrays of up to 10 x T10 cabinets or a
total system weight of 110 kg (242 lb) to be flown in any vertical splay
angle configuration between the cabinets.
For this purpose the Flying frame must be freely suspended using
appropriate steel wires or hoisting chains or using the d&b Z5147 Rota
Clamp (single pickpoint operation). Any other type of suspension of the
Flying frame is not allowed.
For arrays with a total system weight of more than 110 kg (242 lb) the
load conditions within the array have to be checked using the d&b
ArrayCalc calculator, which can be downloaded at
www.dbaudio.com .
T-Series Rigging manual (1.1 EN) Safety precautions - 1/Page 4 of 44