Artesyn Centellis 2000 Shelf - DC Installation and Use (June 2014) - Manual (Page 130)

Network Management and System Access
Centellis 2000 Shelf - DC Installation and Use (6806800G45F) 130
If a MF105 is replaced with a spare MF105 which has not been used before, the Shelf FRU
Validation tool will recognize the default shelf FRU information and update it with the system’s
shelf FRU information after next power-up. The shelf FRU information remains valid.
Replacement during shelf power-off with a already used MF105
If a MF105 is replaced with an already used MF105, the valid shelf FRU information can not be
determined after next power-up. The shelf geographical address will be set to the emergency
address 251.
To get a valid shelf FRU information, log in to one MF105 via telnet or SSH and use the
command shelf_fru_validation with option -p to specify which shelf FRU information
is correct. Afterwards, reboot the shelf.
Example: Declare shelf FRU information of local shelf manager valid:
# shelf_fru_validation -w -p M1
8.3.3 IP Addresses
The following subsections describe the IP addresses of the shelf manager. There are no pre-
defined IP addresses for the node blades.
The shelf manager has three network interfaces: One on the front panel, one to its own hub and
one to the hub of the other MF105. The shelf manager sets up these interfaces based on the
information found in the shelf manager IP connection record of the shelf FRU information.
If the shelf geographical address can not be determined, HPI will not start.