Artesyn Centellis 2000 Shelf - DC Installation and Use (June 2014) User Manual
Page 82
System Installation
Centellis 2000 Shelf - DC Installation and Use (6806800G45F)
82
5. Make sure that the external power feeds you plan to attach are powered off and
cannot be switched on while you are working.
6. Remove the insulation from the ends of the power cables.
7. Crimp the ends of the power cables.
8. Loosen the screws on both sides of the pluggable screw terminals.
9. Remove the pluggable screw terminals from the rear of the shelf.
10.Insert the crimped ends of the power cables to the rectangular openings (3.5 mm
x 3.5 mm wide) of the pluggable screw terminals.
11.Fasten the screws at the bottom of the pluggable screw terminals.
System Damage
Applying feed power to the PEM with the PEM breaker in the ON position damages your
system and/or system components.
The PEM breaker must be in the OFF position when you turn on the feed power.
Product Damage
Improper cabling damages your product.
Take extreme care not to connect the power cable in reverse polarity.