3 blade insertion and extraction, Table 11-2, Available software upgrade tools – Artesyn Centellis 2000 Shelf - DC Installation and Use (June 2014) User Manual
Page 153: Blade insertion and extraction, Software
Software
Centellis 2000 Shelf - DC Installation and Use (6806800G45F)
153
The following table shows which tools you can use and where you can find a description of how
to do it.
Please refer to the Release Notes to find out about software dependencies.
11.3 Blade Insertion and Extraction
This section describes the steps that are carried out by the software when a blade is inserted or
supposed to be extracted. For the actual hardware installation procedures refer to the
documentation of the blade.
Artesyn Embedded Technologies recommends to always use FUMI if available.
Table 11-2 Available Software Upgrade Tools
Procedure
Tool
Document/Chapter
ATCA-MF105 payload upgrade
ATCA-MF105 firmware upgrade
Fan tray IPMC firmware upgrade
FUMI
System Management Interface Based on HPI-B (Centellis
CO 31kX/4100/2000) User’s Guide
Chapter: Using the Firmware Update Management
Instrument
fw_tool
ATCA-MF105 Installation and Use
Chapter: Software Upgrade
BBS software upgrade on any
blade
-
Install the files of the new software version as
described in the Basic Blade Services Software
Programmer’s Reference of the respective blade
Chapter: Installation
Node blade firmware upgrade
Depends on the node blade. Please refer to the documentation of
the respective blade.