Artesyn Centellis 2000 Shelf - DC Installation and Use (June 2014) - Manual (Page 73)

Chapter 3
Centellis 2000 Shelf - DC Installation and Use (6806800G45F) 73
System Installation
3.1 Overview
The following sections help you to start up and maintain the system:
3.2 Before Installation
This section provides the following information:
 Type label location
 Requirements
 Tools you will need
3.2.1 Type Label Location
The serial number label for the shelf is located at the system’s right hand side.
3.2.2 Requirements
Please ensure that the requirements outlined in section Requirements on page 65 are met.
To maintain the maximum power rating of the system, the power input cables must have a
minimum cross section of 4 mm
2
, AWG 12.
Step Description
Before Installation on page 73 This section provides information about the requirements,
unpacking and inspecting the delivery and the type label
location.
Installation on page 74 This section provides information about how to mount the
system into a rack and how to ground the system.
Removal on page 85 This section provides information on how to power down the
system and remove it from a rack.