Artesyn Centellis 2000 Shelf - DC Installation and Use (June 2014) - Manual (Page 21)

Safety Notes
Centellis 2000 Shelf - DC Installation and Use (6806800G45F) 21
 The protective bonding conductor depends on your power distribution topology. Make
sure that you use an appropriate protective bonding conductor regarding the rating of the
branch circuit protection.
 Install the system safely. Make sure that cables and cords are out of the way.
 Make sure that the set-up is comfortable for users.
System Damage
Environmental contamination can impair system operation.
Locate the system in a stable area free of excess movement and jarring and free of dust, smoke,
and electrostatic discharge (ESD). Make sure that the temperature does not exceed the
operating temperature given in the environmental requirements in this manual and allow
room for proper air flow for cooling.
Personal Injury or System Damage
The system is supplied by a TNV-2 voltage. This voltage is considered hazardous. Make sure
that the power supply meets the relevant safety standards.
Ensure that TNV-2 is separated from dangerous voltages (mains) through double or reinforced
insulation.
Personal Injury or System Damage
A top-heavy rack can topple over, causing damage to equipment and injury to personnel.
If your system is the only one in the rack, make sure to mount the system in the lowest part of
the rack. If several systems are installed in one rack, start with the heaviest component at the
bottom. If the rack is equipped with stabilizing devices, make sure that they are installed and
extended so that the rack is secure. Then proceed to mount or service the system.
Personal Injury or System Damage
When pulling the system out of the rack, it can fall down and cause injuries.
Pull out the system cautiously.