Artesyn PrAMC-7311 Installation and Use (June 2014) - Manual (Page 18)

PrAMC-7311 Installation and Use (6806800P34D)
Safety Notes
18
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense. Changes or
modifications not expressly approved by Artesyn Embedded Technologies could void the
user's authority to operate the equipment. Board products are tested in a representative
system to show compliance with the above mentioned requirements. A proper installation in
a compliant system will maintain the required performance. Use only shielded cables when
connecting peripherals to assure that appropriate radio frequency emissions compliance is
maintained.
Operation
Product Damage
Surface of the Product
High humidity and condensation on the product surface causes short circuits.
Do not operate the product outside the specified environmental limits. Make sure the product
is completely dry and there is no moisture on any surface before applying power.
Overheating and Product Damage
Operating the product without forced air cooling may lead to overheating and thus damage of
the product.
When operating the product, make sure that forced air cooling is available in the shelf.
Data Corruption
If power to the blade is removed while the BIOS is still updating changes to the flash, the
changes will not be saved, and worse, the flash may be corrupted.
Whenever you select the Exit Saving Changes option to save changes to BIOS setup and exit,
do not power the blade down before BIOS reboots.
Product Damage or Loss of Regulatory Compliance
The serial port is meant for development/debug/craft purpose only.
The serial cable is not meant to be connected during normal field operation. The PrAMC-7311
has not been qualified for regulatory compliance with the serial cable connected.