Figure 6-1, Main menu, Basic input output system – Artesyn PrAMC-7311 Installation and Use (June 2014) User Manual
Page 64
Advertising
Basic Input Output System
PrAMC-7311 Installation and Use (6806800P34D)
64
Press <F2> when the message Press <F2> to enter SETUP appears on the screen. The
following main menu appears as below:
Select either [Exit Saving Changes] or [Save Changes] after making a selection in the setup
menus. Both procedures store the selections displayed in the menus in CMOS. At next boot up,
BIOS configures the system according to the setup selection stored in CMOS. Refer to
for more details.
CMOS is a generic term that is used to refer to the storage device that stores BIOS configuration
data.
Figure 6-1
Main Menu
For the F2 message to appear, you should enable the Diagnostic Splash Screen in the
Advanced menu.
Advertising