Artesyn PrAMC-7311 Installation and Use (June 2014) - Manual (Page 20)

PrAMC-7311 Installation and Use (6806800P34D)
Safety Notes
20
Artesyn Embedded Technologies and our suppliers take significant steps to ensure there are
no bent pins on the backplane or connector damage to the boards prior to leaving the factory.
Bent pins caused by improper installation or by inserting boards with damaged connectors
could void the Artesyn Embedded Technologies warranty for the backplane or boards.
Cabling and Connectors
Product Damage
The RJ-45 connector(s) on the face plate are either twisted-pair Ethernet (TPE) or E1/T1/J1
interfaces. Connecting an E1/T1/J1 line to an Ethernet connector may damage the product.
 Make sure that TPE connectors near your working area are clearly marked as network
connectors.
 Verify that the length of an electric cable connected to a TPE bushing does not exceed 100
m.
 Make sure the TPE bushing of the product is connected only to safety extra low voltage
circuits (SELV circuits).
If in doubt, ask your system administrator.
Battery
This product utilizes a lithium battery which can only be replaced by qualified service
personnel.
Caution: Risk of explosion if the battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
Environment
Always dispose of used AMCs, system components and RTMs according to your country’s
legislation and manufacturer’s instructions.