Artesyn PrAMC-7311 Installation and Use (June 2014) - Manual (Page 37)

Hardware Preparation and Installation
PrAMC-7311 Installation and Use (6806800P34D) 37
2.4 Module Installation and Removal
This section describes how to install and remove an AMC module.
Installation Procedure
The following describes how to install an AMC module into an AMC bay of the base board. The
installation procedure assumes that the AMC module is being hot-inserted, that means the
base board is powered. The procedure for the cold insertion, that means the base board is not
powered, is the same, except that you need not wait for the blue LED indications to proceed.
1. Make sure you are in an ESD-safe environment.
2. Identify the AMC bay to be used for the installation.
3. If the required AMC bay is occupied by an AMC filler panel, you will need to remove
the filler panel before proceeding with the installation procedure. The removal
procedure for the filler panel is the same as described in the Removal procedure
which follows immediately after this procedure. Ignore steps that mention the blue
LED.
Damage of Circuits
Electrostatic discharge and incorrect product installation and removal can damage circuits or
shorten their life.
Before touching the product or electronic components, make sure that you are working in an
ESD-safe environment.
Product Malfunctioning
Incorrect product installation and removal can result in product malfunctioning.
When plugging the product in or removing it, do not press on the face plate but use the handles.
Limitization of Operating Temperature Range
Installing AMC modules with small operating temperature ranges onto the blade may further
restrict the operating temperature range of the blade.
Make sure that the operating temperature of any installed AMC modules and the blade as a
bundle are within allowed limits.