Artesyn PrAMC-7311 Installation and Use (June 2014) - Manual (Page 36)

Hardware Preparation and Installation
PrAMC-7311 Installation and Use (6806800P34D) 36
2.3.3 Power Requirements
Make sure that the module is used on an approved AdvancedTCA carrier board in an
AdvancedTCA shelf connected to -48 VDC up to -60 VDC, for use in a restricted access area only
by trained personnel. All circuits are safety-extra-low-voltage (SELV) under normal operating
conditions, and are not subject to over voltages/transients.
The module provides two independent power inputs according to the AdvancedTCA
specification.
Table 2-2 DC System Power Requirements
Feature Value
Rated voltage 12 VDC
Operating voltage 10 VDC to 14 VDC
Input current 5 A at 12 V
Power dissipation 30 W (Typical)
60 W (max)