Artesyn PrAMC-7311 Installation and Use (June 2014) - Manual (Page 38)

Hardware Preparation and Installation
PrAMC-7311 Installation and Use (6806800P34D) 38
4. Ensure that AMC module handle is in the extracted position: pulled outward, away
from the face plate.
5. Using your thumb, apply equal and steady pressure on the face plate as necessary
to carefully slide the AMC module into the guides rails.
6. Continue to gently push the module along the guide rails till the module is fully
engaged with the connector. Avoid using excessive force during this operation.
7. Wait for the blue LED to glow. The blue LED glows when the AMC module is
completely engaged with the connector.
8. Press module handle inwards toward the face plate to lock the AMC module on
AMC bay.
9. Wait for the blue LED to perform a series of long blinks. The blue LED blinks when
the handle is locked in position indicating module detection and activation by the
carrier board.
10.Observe blue LED status/activity. The module is fully installed when the blue LED
stops blinking and stays OFF.
Removal Procedure
The following describes how to remove an AMC module from the base board. The procedure
assumes that the base board is powered. If it is not powered, the steps regarding the blue LED
can be ignored and skipped.
1. Make sure you are in an ESD safe environment.
2. Remove any cables that are connected to the AMC module face plate connectors.
3. Gently pull the module latch outward, approximately 3 mm from its locked
position.