Datalogic Scanning 9500 - Manual (Page 380)

6-264
Magellan ® 9500
MSI/Plessey Maximum Label Length
This feature specifies the maximum allowable length of an MSI/Plessey
label.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan the bar code, SET MSI/PLESSEY MAXIMUM LABEL
LENGTH below. You’ll need to cover any unused bar codes on this
and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C that rep-
resent the desired maximum label length. The selectable range for
this option is 4 to 16. Pad all single digit numbers with a leading
zero to yield a two-digit entry (04-16).
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET MSI/PLESSEY MAXIMUM LABEL LENGTH
NOTE
Length in this case includes check and data characters, but does not include
start, stop or full ASCII shift characters. This feature applies when
MSI/
Plessey Length Control is set to variable-length decoding.
Maximum label length should be greater than or equal to minimum label
length.