Datalogic Scanning 9500 - Manual (Page 58)

2-30
Magellan ® 9500
Figure 2-14. Physical Measurements: Remote Display (Short Base)
6. Cut the stalk to fit your installation (if required).
7. Route the cable through the base/stalk so that you can plug the con-
nector into the display head.
8. Remove the rubber band from the connector and attach the connec-
tor to the display head.
9. Slip the display head onto the stalk/base.
10. Feed the entire remaining length of the Remote Scale Display inter-
face cable through the cable routing hole so that the assembled
Remote Scale Display can be positioned over the mounting screw
holes.
Minimum
5.5"
(14.0 cm)
Maximum
11.75"
(29.8 cm)
5.8"
14.7 cm
3.0"
7.6 cm
1.5"
3.8 cm
4.5"
31.6 cm
3.375"
0.953 cm
0.95"
2.4 cm
0.00
lb