Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 108)

VMS Quick Configuration Guide MN/22156, rev 12
3-8 VMS User Guide
4. For Hub(s) and initial Remote(s):
• Create the network Antennas
• Create the antenna Up Converters and Down Converters
• Bind the Mods and Demods to the Converters for these sites
Configure Network Manager [ page 3-41 ]
1. Create the Network(s).
2. Drag-and-drop the Satellite(s) from RF Manager to the network(s).
3. Optional: Create the Groups for the network(s).
4. Create the Sites for the network or group—Hub(s) and initial Remote(s).
5. Drag-and-drop the site Antennas into the sites.
6. Drag-and-drop the site Subnets into the sites.
Set Carrier Flags [ page 3-46 ]
1. Set the STDMA flag on the network Burst Controller.
2. Set the flags for the Allocatable Mods and Demods:
• P2P Switching Modulators at the Hub
• SCPC Switching Demodulators at the Hub
• Mesh Demodulators at the Remotes
Mask Rx Unlock Alarms [ page 3-50 ]
Select Mask Unlock Alarm for all network units that function as either a Burst
Controller (not necessary for SLM-5650/A) or an Expansion unit.
Configure InBand Management [ page 3-54 ]
1. Set the InBand flag for each Remote site.
2. Configure the InBand Settings and Home State.
• InBand Transmit Settings
• InBand Receive Settings
3. Set the InBand Bandwidth Reservations.
4. Set the InBand Policies for the Network level, Group level, and Site level.
• InBand Policy Flags
D.