Flowserve MX-100 Field Unit - Manual (Page 32)

MX/DDC-100 Field Unit Installation and Maintenance FCD LMENIM2329-01 – 03/11
32
2. Separate the cable parts. Unbraid the shield and peel back the foil shield to the same point where the outer jacket
was removed as shown in Figure 3.3.
Figure 3.3 – Separating cable parts
3. Cut away the braided shield and the foil shield. Strip the insulation from the conductors approximately 0.4 inch (1
cm) as shown in Figure 3.4.
Figure 3.4 – Stripping conductors