GAI-Tronics VoIP Telephone Software Configuration Guide - Manual (Page 13)

GAI-TRONICS
VoIP Telephone Configuration Guide Page 13 of 88
In this example, Output 1 is set to activate a flashing beacon, whilst Output 2 is set to activate
a sounder in sync with the cadence of the ring signal (set on the Tone settings page). In both
cases the outputs are energised when the phone is ringing with an incoming call, and de-
energised when the call is answered or disconnected.
Refer to the Logic Settings page (section 5.17) and Tone settings page (section 5.15) for
more details.
4.2.6 How do I set up a door-entry system?
A common application is to have a single button hands-free telephone mounted outside a
door, and a 15 button Commander model at a remote security point. Visitors arriving at the
door use the hands-free unit to call the security point. A security guard answering the call can
release the door lock by pressing the "R" button on the Commander unit.
To achieve this, connect one of the volt-free outputs on the hands-free telephone (say output
1) to the electronic door release mechanism. Using the Logic settings page, set this output to
PULSE:
Note that the TIMER is set to 3, meaning that the output will remain active for 3 seconds after
being activated.
To activate this output from the security office, set the RECALL setting on the Key mapping
page of the Commander unit to the IP address of the hands-free unit. So, for example, if the
IP address of the hands-free were 192.168.9.2, the setting would be:
3XE  D