8 email settings – GAI-Tronics VoIP Telephone Software Configuration Guide User Manual
Page 27
GAI-TRONICS
VoIP Telephone Configuration Guide
Page 27 of 88
Speeds available (from a drop-down list) are: 9600, 19200, 38400, 56700 & 115200 baud.
The default value is 115200.
The other parameters for serial comms are: 8 data bits, 1 stop bit, no parity.
5.8 Email
settings
The telephone can report various alarm and input conditions via email (see the ALARMS and
LOGIC pages in sections 5.14 and 5.17). The Email settings page is used to set the
parameters required.
SERVER1: Sets the primary SMTP server, as an IP address or a FQDN
SERVER2: Sets the secondary SMTP server, as an IP address or a FQDN, for redundancy.
TOADDRESS, CCADDRESS & FROMADDRESS: Set the email addresses that will appear
in the message. Note that the phone can send the message to two separate addresses (TO
& CC) Each of these fields can contain a single email address of the form [email protected]
SUBJECT: Sets the subject that will appear with each email message from this unit.
SMTP: enables or disables email.
3XE
D