GAI-Tronics VoIP Telephone Software Configuration Guide - Manual (Page 50)

GAI-TRONICS
VoIP Telephone Configuration Guide Page 50 of 88
ON Sets the output permanently on.
OFF Sets the output permanently off.
PULSE +
Sets the output to activate once only for the period defined by the
TIMER field, on receipt of a Recall signal from a remote phone.
MUTE + Sets the output to indicate if the audio input is muted.
RING +
Sets the output to pulse when an incoming call is ringing. The pulsing
on /off periods are set by the CADENCE field.
CALL +
Sets the output to pulse when an outgoing call is active. The pulsing
on /off periods are set by the CADENCE field.
CONNECT + Sets the output on when a call is connected.
HOOK +
Sets the output on when the telephone is off hook, and off when it is
back on hook.
INUSE +
Sets the output on when an incoming call arrives or when the user
goes off hook for an outgoing call, and off when the call ends.
RINGCADENCE + Causes the output to pulse in time with the ring tone cadence.
RINGOUT +
Sets the output to pulse when an outgoing call is ringing (but not yet
connected). The pulsing on /off periods are set by the CADENCE
field.
PAGE +
Sets the output to pulse when a call is present that has been signalled
as a PAGEMODE call (see UNIT page, section 5.5). The pulsing on
/off periods are set by the CADENCE field.
REGISTERED +
Sets the output to pulse when the phone is registered with at least one
SIP server. Can be used as a “phone available” indicator. The pulsing
on /off periods are set by the CADENCE field.
EMERGENCY +
Sets the output to pulse whenever there is an outgoing call present
that has been initiated by an EMERGENCY button. The pulsing on
/off periods are set by the CADENCE field.
The ON and OFF keywords must be used on their own. The other keywords (indicated by a +
symbol in the table above), can be combined and entered in any order, separated by a plus
(+) character. For example to set an output to pulse when an incoming call is ringing, and be
on steadily when the call is connected enter RING+CONNECT.
TIMER: Sets the timer value for the PULSE command in seconds. Default value is 3. The
minimum is 0 & the maximum is 3600.
CADENCE: Sets the cadence for those keyword commands that require it. The cadence is
entered as two numbers separated by a colon (:) character, representing the on and off times
in tenths of a second. For example to set a cadence of 1 second on, half a second off, enter
10:5.
5.18 Multicast settings
Multicast is a factory option which must be specified at order time. If the phone was not
ordered with Multicast, this page will not appear.
Multicast allows a single audio stream to be sent to multiple endpoints simultaneously, to
achieve multi-point paging or Public Address functionality over IP. As such it is only
applicable to telephones with a loudspeaking capability such as handsfree units and Help
Points
Multicast requires the use of a SIP server that specifically supports it, and each endpoint (ie
phone) must be individually configured to receive multicast packets.
When making a multicast call, the SIP server will send a paging request to a specific IP
address and expect multiple phones to accept and play the subsequent audio.
The GAI-Tronics phone can be programmed with up to 8 multicast IP addresses to allow the
receipt of multicasts from different sources or to enable zoning of multicasts.
Each multicast address can be assigned a priority to define which can override which.
A phone with multicast enabled can still make and receive normal calls. Normal calls can
also be assigned a priority level, defining whether calls can override multicasts or vice versa.
3XE  D