4 key module command line syntax, 5 led module command line syntax, 3xe d – GAI-Tronics VoIP Telephone Software Configuration Guide User Manual
Page 76
GAI-TRONICS
VoIP Telephone Configuration Guide
Page 76 of 88
9.4
KEY Module Command Line Syntax
Action
Verb
Parameters
Comment
1 2
SET
RECALL xxx.xxx.xxx.xxx
This command sets the destination unit IP
address and output number for a relay contact
that will be operated when the RECALL key is
pressed. The command will be sent using an
extension to the proprietary protocol defined
for passing logic states.
(No implemented in first release)
INHIBIT
DIGIT +
If this parameter is set then all digit keys will
be disabled during an emergency call.
MEMORY +
If this parameter is set then all memory keys
will be disabled during an emergency call.
CLEAR +
If this parameter is set then any key will
capable of initiating a call clear be disabled
during an emergency call.
NONE
This command clears all key inhibit settings (
DEFAULT VALUE)
RELAY1ONCODE
XXXX[XX]
These codes set relays OUTPUT1 and
OUTPUT2 to activate on receipt of a matching
string of DTMF characters from the remote
party during a call. Outputs can be set to turn
ON, OFF or to PULSE for a fixed duration
below. Strings must be min 4 max 6
characters. Valid characters are 0-9, A-D, *,#.
Blank disables. Default value blank.
RELAY2ONCODE
RELAY1OFFCODE
RELAY2OFFCODE
RELAY1PULSECODE
RELAY2PULSECODE
RELAY1PULSELEN
1-60
Duration in seconds that an output will remain
ON following receipt of a
RELAYxPULSECODE. Range 1-60.
RELAY2PULSELEN
SHOW ALL
This command shows the current settings of
the RECALL and INHIBIT settings and lists the
key map settings.
9.5
LED Module Command Line Syntax
Action
Verb
Parameters
Comment
1
2
3
MODE
HELPPOINT
Refer to web page section for function
descriptions
DDA
OFF
SET LED
[1|2|3]
GENERATE
OFF
PULSE +
MUTE +
RING +
CALL +
CONNECT +
HOOK +
INUSE +
RINGCADENCE +
PAGE +
REGISTERED +
EMERGENCY +
ON
TIMER XX
CADENCE ON:OFF
SHOW ALL
Shows the current settings of all the LED
parameters
3XE
D