15 smtp module command line syntax, 16 status module command line syntax, 3xe d – GAI-Tronics VoIP Telephone Software Configuration Guide User Manual
Page 83
GAI-TRONICS
VoIP Telephone Configuration Guide
Page 83 of 88
9.15 SMTP Module Command Line Syntax
Action
Verb
Parameters
Comment
1 2
3
SET
SERVER1
or
SERVER2
xxx.xxx.xxx.xxx
or
FQDN
Sets the IP address of the primary SMTP server to be
xxx.xxx.xxx.xxx or uses the FQDN to resolve the IP
address through DNS. E-mail will be sent on assertion
of an alarm condition via the primary server if
configured.
xxx.xxx.xxx.xxx
or
FQDN
Sets the IP address of the secondary SMTP server to
be xxx.xxx.xxx.xxx or uses the FQDN to resolve the IP
address through DNS. E-mail will be sent on assertion
of an alarm condition via the secondary server if
configured.
TOADDRESS
Sets the To: Address
CCADDRESS
Sets the CC: Address
FROMADDRESS
Sets the FROM: Address
SUBJECT “SubjectText”
Set the contents of the subject field to be “SubjectText”.
The Subject Text field can be up to 50 characters in
length, and can contain any printable character except
double quotes.
OFF
This command disables the sending of SMTP alerts
ON
This command enables the sending of SMTP alerts if
the above server settings and addresses are
configured
SHOW ALL
9.16 Status
Module
Command Line Syntax
Action
Verb
Parameters
Comment
1 2
3
SHOW ALL
This command shows the current call status, the state
of all auxiliary inputs and logic outputs, and the
registration status of the 4 SIP proxies and registrars
3XE
D