GAI-Tronics VoIP Telephone Software Configuration Guide - Manual (Page 23)

GAI-TRONICS
VoIP Telephone Configuration Guide Page 23 of 88
HOSTNAME: Sets the unit host name. Maximum 15 alphanumeric characters (a-z, A-Z , 0-9).
Default Value is a unique string starting with "GT" and followed by the serial number of the
main circuit board inside the phone (referred to as the "Board serial" on the home page). The
host name identifies the unit on the network, and is also used in email and syslog messages
to identify the source of the message. If using DHCP, this field must be kept unique for each
phone on the system.
UPDATE SERVER: Sets the address of the host running the TFTP server. (Valid values: IP
address or FQDN. Default value: blank)
UPDATE FILE: The name of the update control file on the update server. This name may
contain the macro symbols %m, %h and %i. These symbols are expanded to the MAC
address, host name and IP address respectively. (Default value: blank)
UPDATE INTERVAL: Forces the unit to attempt a file download every X hours where X can
be an integer value between 0 and 1000. A value of 0 disables the periodic update request.
The default value is 1. Any non-zero value will cause the unit to attempt a configuration file
download at boot time.
HELPSERVER: Sets the default address for the Help web page reached from the link on the
home page. The default value is http://www.gai-tronics.co.uk/voipsupport.htm, but it can be
changed to any appropriate page available on the network.
LAN SPEED: Sets the speed or auto negotiation status for the WAN Ethernet port. Valid
values: 10, 100 or AUTO. Default value: AUTO. If the speed is auto negotiated the duplex
setting has no effect.
LAN DUPLEX: Sets the duplex value for the WAN Ethernet port. Valid values: FULL or HALF.
Default value: FULL.
CONFIGID: Used by the configuration upgrade script to determine if the local configuration is
the same as the one it wants to upgrade to. If this matches the CONFIGVERSION line in the
update control file, no download will take place. Default value: blank.
ANI: Used as an identifying token to GAI-Tronics CMA Call Management Application. Default
value: "GAIPHONE". Maximum 12 characters.
DEFAULT_ANS_MODE: Sets the default answer mode. This mode will be used to answer a
call when ANSMODE1, ANSMODE2 and PAGEMODE are not triggered. Values available are
RING, PICK-UP, PAGE and STEALTH. RING is normal phone operation, where a button
must be pressed or handset lifted to answer an incoming call. PICK-UP is as described in
ANSMODE2 below. PAGE is as described in PAGEMODE below. STEALTH is as described
in ANSMODE1 below. Default value: ‘RING’.
The next 3 fields set “passwords” that can be used by GAI-Tronics CMA to activate 3 special
auto-answer modes, usually for hands-free telephone types.
ANSMODE1: Stealth auto-answer mode, where the telephone provides no indication of the
incoming call and immediately auto answers the call. The speaker is muted, and the
microphone gain is enhanced. Sending a DTMF ‘*’ during a call will change the unit to
ANSMODE 2. For activation from CMA, set this field to "aa1"
ANSMODE2: Sets Intercom auto-answer mode, where the telephone auto answers and
provides normal duplex audio, preceded by an announcement tone. For activation from CMA,
set this field to "aa2"
PAGEMODE: Where the unit auto answers and disables the microphone. A "splash" tone
(tone 9) is emitted from the speaker to alert those nearby of an impending page
announcement. The output level of the speaker is increased to its maximum level. For
activation from CMA, set this field to "aa3"
3XE  D