3 ip settings – GAI-Tronics VoIP Telephone Software Configuration Guide User Manual

Page 17

Advertising
background image

GAI-TRONICS

VoIP Telephone Configuration Guide

Page 17 of 88

At the bottom of the home page (you may need to scroll down, depending on screen
resolution) there is a list of information about the phone including serial numbers of the unit
and its PCBs, software versions and MAC ID.

5.3 IP

settings

The IP settings page is used to display or change various settings for connection to the IP
network.


DHCP
: Enables or disables the use of DHCP for the assignment of IP parameters. If this
value is set to OFF the telephone will use the Static IP values. (Values available: ON or OFF,
default value is OFF)
ADDRESS: Sets the static IP Address of the unit. (Default value is 192.168.1.2) Do not enter
a value here if DHCP is set to ON.
MASK: Sets the static sub-net mask. (Default value is 255.255.0.0) Do not enter a value here
if DHCP is set to ON.
GATEWAY: Sets the static default gateway address (Default value is 0.0.0.0)
DNS1: Sets the IP address of the primary static DNS server. If DHCP is enabled then this
DNS server will not be used. (Default value is 0.0.0.0 )
DNS2: Sets the IP address of the secondary static DNS server for redundancy. If DHCP is
enabled then this DNS server will not be used. (Default value is 0.0.0.0 )
LOCALDOMAIN: Sets the domain name of the telephone on the network, as used by DNS.
May be assigned by DHCP.
WEB: Enables or disables access to the web server (Values available: ON or OFF, default
value is ON)
WEBPORT: Sets the TCP port through which the Telephone Web server can be accessed
(Default Value is 80)
TELNET: Enables or disables access to the telnet server (Values available: ON or OFF,
default value is ON)
TELNETPORT: Sets the TCP port through which the Telephones telnet server can be
accessed (Default Value is 23)
SYSLOG: Sets the destination address for syslog server messages. (Valid values: IP
address or FQDN. Default value: blank)
SYSLOGPORT: Sets the port number to be used for syslog messages. The default value is
514

3XE

D

Advertising