GAI-Tronics VoIP Telephone Software Configuration Guide - Manual (Page 38)

GAI-TRONICS
VoIP Telephone Configuration Guide Page 38 of 88
DTMF: Sets the transmission of DTMF digits to be either in band or out of band. The default
setting is out of band, when DTMF is transmitted using RFC 2833.
DTMFPT: Sets the payload type parameter in the RTP packets when sending DTMF tones
'out-of-band' according to RFC2833. The default value is 96, but should be changed to 101
when using Cisco CallManager™.
DTMFPLAYBACK: sets whether DTMF tones are heard in the earpiece when digit buttons 0-
9, * or # are pressed. Default value OFF.
HANDSETVOLUME: If the telephone is a handset model, this parameter sets the handset
earpiece volume. The range is 1-9 and the default value is 8. If the telephone is a hands-free
model, this setting has no effect.
HANDSFREEVOLUME: If the telephone is a hands-free model, this parameter sets the
speaker volume. The range is 1-12 and the default value is 3. If the telephone is a handset
model, this setting has no effect.
LINEVOLUME: This parameter is for future enhancements and has no effect.
Note: these volume settings set the starting volume within the available range. If the
telephone has a volume control button or buttons, these will only act up to the extents of the
range. In other words if the volume is set to its maximum on the web page, a “VOLUMEUP”
button will have no effect.
RINGERVOLUME: This parameter sets the ringer volume for both handset and hands-free
models. The range is 1-12 and the default value is 10.
HANDSETGAIN: If the telephone is a handset model, this parameter sets the handset
microphone gain. The range is 1-8 and the default value is 6. If the telephone is a hands-free
model, this setting has no effect.
HANDSFREEGAIN: If the telephone is a hands-free model, this parameter sets the
microphone gain. The range is 1-8 and the default value is 3. If the telephone is a handset
model, this setting has no effect.
LINEGAIN: This parameter is for future enhancements and has no effect.
JITTERMIN: Minimum size of dynamic jitter buffer. Range is 30-120. Default value is 30.
JITTERMAX: Maximum size of dynamic jitter buffer. Range is 30-120. Default value is 60.
3XE  D