GAI-Tronics VoIP Telephone Software Configuration Guide User Manual
Page 40
GAI-TRONICS
VoIP Telephone Configuration Guide
Page 40 of 88
The available alarms are:
# Description Function
Defaults
1 Handset
Integrity Loop
Signals a broken handset loop.
Default ON and OFF times
5s
2 Configuration
Error
Signals that the configuration file
currently used by the unit has one or
more entry errors which have been
ignored.
Default ON time is 0, OFF
time is not applicable
3
Cold Reset
Signals that the unit has reset due to a
power cycle.
Default ON time is 0, OFF
time is not applicable.
4
Warm Reset
Signals that the unit has reset due to an
internal software command or error.
Default ON time is 0, OFF
time is not applicable.
5 Transducer
Fault
Not implemented.
6
Keypad Error
Signals that a key has remained
pressed for the entire ONTIME period.
Default ON and OFF times
6s.
7
Key Hook
Signals an off hook condition in excess
of the ONTIME when not in a call.
Default ON time 30s, OFF
2s.
8
Register Fail
Signals a failure to register with all
enabled proxy servers for a period in
excess of the ONTIME. This alarm will
not occur if registration is maintained
with at least one of the enabled
registrars on the SIP pages.
Default ON time is 360s,
OFF time is not applicable.
9 Audio
Path
Test
Signals a failure of an audio path test as
configured on the UNIT page.
Note that a status of "ON" means that
the test has failed.
ONTIME and OFFTIME
are not applicable.
For each alarm, the following parameters can be set:
REPORT: specifies if an alarm will be generated on assertion of an alarm condition only
(ON), on removal of the alarm condition only (OFF), on either event (ON+OFF) or not at all
(NONE)
STATUS: This field shows the current status of the alarm (not a changeable parameter).
3XE
D