NewTek 3Play 820 - Manual (Page 57)

Page | 43
4.5.2 ONE–BUTTON MARKING
26. Finish marking any incomplete event, if necessary, by pressing OUT.
27. Wait for a few more seconds to elapse, and then press OUT only – without pressing IN
first.
28. Repeat this step a few times, allowing a few moments to pass between repetitions.
Notice that even though you haven’t pressed IN first, new ‘complete’ events have been added to
the Clips List. By default, the duration for each of these new events is four seconds. The Out
Point was set when you pressed OUT, and a suitable In Point is assigned as required.
4.6 CLIPS LIST NAVIGATION
29. Hold down ALT, and press the | (Next) button.
Nothing happens. This is because you are still in LIVE mode.
30. Press the CLIP LIST control mode button. A bright border is added to the Clips List
module, and the HUD for Output B also updates (to CLIPS). Both of these are indicate
that Output B is now in Clips control mode.
31. Hold down ALT, and press the | (Next) button again. You’ll see that the view on the
current output updates to show the second camera angle, and the gold highlight in the
Clips List moves to the Memo column for the second clip in the event row.
32. Hold ALT down again, and press | (Previous) to return to the first camera angle. (Press
Previous or Next without ALT to move up or down in the Clips List.
4.7 ADDING A MEMO
33. Press F2 (or alternatively, the Enter key) on the keyboard. Note that this places the
currently highlight Memo field into text edit mode.