SIGMA ELECTRONIC FLASH EF-610 DG SUPER EO-ETTL II (キヤノン用) - Manual (Page 23)

22
5. After pressing the SEL button again, the flash power level will blink.
6. Press the + or - button to set the desired power level.
7. Press the SEL button again, the number of flashes will blink.
8. Press the + or - button to set the desired number of flashes.
9. Press the SEL button again, the display will stop blinking.
10. When the ready light of the flash is illuminated, the unit is ready to use.
Note: Please set the shutter speed longer than; Number of Flashes you want ÷ Firing Frequency
BOUNCE FLASH
When you take a photo with flash in a room, sometimes a strong shadow will appear behind the subject,
if you point the flash head upwards or sideways to reflect the light off the ceiling, wall etc. the subject
will be illuminated softly. Press the lock button and adjust the flash head to set the bounce angle.
UP: 0°, 60°, 75°, 90°
DOWN: 0°,7°
RIGHT: 0°, 60°, 75°, 90° LEFT: 0°, 60°, 75°,90°, 120°, 150°, 180°
When the bounce flash mode is activated, a bounce indicator
will appear on the LCD panel.
Choose a white surface for bouncing the flash, otherwise the
image’s colour may be incorrect.
Depending on the reflecting surface, the subject distance and other
factors, the effective distance range for the TTL AUTO may change.
Please check for correct exposure confirmation (ETTL or TTL mark
on the LCD panel) after releasing the shutter.
CLOSE-UP EXPOSURES
Bounce flash can be tilted 7° downward for close-ups. The Flash will be effective only for the subjects
0.5 meter to 2 meters. When the flash head is tilted 7°,
will blink.
CATCH LIGHT PANEL
This flash is equipped with a built-in catch
light panel, which can create a catch light in
the eyes of the subject when the bounce
flash mode is activated. Slide out the wide
panel and catch light panel, and then put
wide panel back in its place. (Be careful to
slide the panels out smoothly.)
◆ To create a catch light effectively, tilt the flash head upward 90 degrees and take pictures at a close
distance.
WIRELESS FLASH
When using the “Wireless Flash” mode, you can take pictures with a more three-dimensional feeling,
or make natural images by using shadowing depending on the flash position. This can be done without
any extension cord connecting the camera body and flash. In case of the EF-610 DG SUPER,
communication between the camera body and the flash will be achieved by the light produced by the
flash. In the “Wireless Flash” mode, the camera will calculate the correct exposure automatically.
◆ The type A camera models can be used with “Wireless Manual Flash” and “Wireless Multi Flash”
functions only. The EOS750 and EOS850 cannot be used with “Wireless Flash”.
◆ In this instruction we call the flash unit which is attached to the camera body the “Master unit ” and
we call a flash unit at a remote position a “Slave unit”.
◆ When setting a slave unit at the desired position, you can use the mini-stand provided. This
mini-stand has a screw hole for a tripod.
◆ Place the slave flash unit at the desired location. Do not place the slave unit within the picture area.