Teac DR-07MKII - Manual (Page 38)

38
TASCAM DR-07MKII
Powering the unit
DR-07MKII can operate on two AA batteries, or
through an optional AC adapter (TASCAM PS-P515U)
or USB cable provided with the unit (USB bus power).
Alkaline or Ni-MH batteries can be used.
Using AA batteries
Open the battery compartment cover on the
back of the unit. Fit two AA batteries to the + and
– marks shown in the compartment, and close
the battery compartment cover.
When using AA batteries, set the type of battery
in order to accurately show the amount of power
remaining and allow the unit to accurately determine
whether power is available for proper operation. (See
“Setting the type of AA batteries” on page 110.)
NOTE
Manganese dry cell batteries (R6) cannot be used with •
this unit.
This unit cannot recharge Ni-MH batteries. Use a
•
commercially available recharger.
The included alkaline batteries are for confirming
•
operation of the unit and might not last very long.
Using an AC adaptor (sold separately)
Connect the PS- P515U AC adaptor and the USB cable
to the USB port of the unit as shown in the illustration.
AC Outlet
TASCAM
PS-P515U
USB (mini B) plug
3–Preparation