Teac DR-07MKII - Manual (Page 91)

TASCAM DR-07MKII
91
NOTE
The pop-up message of “I/O Too Short” appears if the •
section between the IN and OUT points is too short. Set
them again. The section should be 1 second or longer.
Press the
• MARK button again to clear the IN and OUT
points.
To stop loop playback, press the MENU button when the
•
Playback Control screen is open. Press the MENU button
again to start loop playback between the set IN and OUT
points.
You cannot set the IN and OUT points in different files.
•
The previous IN and OUT point settings are lost when you •
set the IN point on a different file.
Accurate assignment of IN and OUT points is not always
•
possible for variable bit rate (VBR) MP3 files.
Changing the playback speed (VSA)
The unit features the VSA (Variable Speed
Audition) function that changes the playback
speed without changing its pitch.
CAUTION
The VSA function cannot be effective for files recorded with a
sampling frequency of 96kHz, and
will be shown in
the Home Screen. However, the setting of playback speed can
be changed. To apply the adjustment of playback speed,
select a file recorded with a sampling frequency of 44.1 kHz
or 48 kHz by using the  or¯ button.
Press the + or – button after opening the
Playback Control screen to increase or decrease
the playback speed.
The VSA function can change the playback speed
in the range from 0.5 (50%) to 1.5 (150%) times
(in 0.1 increments) the normal speed.
Press the PB CONT button to the Home Screen
while maintaining the set playback speed
effective. The or icon appears if the
playback speed is set to a value larger or smaller
than 1.0, respectively.
6–Playback