Eneo GXC-1720M - Manual (Page 33)

33
5.1 Microsoft Internet Explorer
5.1.1 Connecting the
IP camera
1. Start up the Microsoft Internet Explorer, and then follow the steps below to connect the IP
camera.
2. Click on the URL block at the top of the window.
3. Enter the URL address of the IP camera into the URL block and press the “Enter” button to
enter the home page.
4. Enter the "User Name" and "Password" in the appropriate spaces.
5. Click on the “OK” button to set your entries, and automatically exit the page.
NOTE:
The default "User Name" and "Password" are admin and admin, respectively.
NOTE: The page headlined "Enter Network Password” is shown below. Please enter the
user name and password of the IP camera when you see it. If either the user name
or the password is incorrect, please check the input data and rectify it as
necessary.
NOTE: Once authorized successfully, the login page will not appear again until you close
the window and reconnect it.
NOTE: The initial sequence of proceeding is to type in your IP address and click the
"Enter" button to access the home page. If and when you revise or change data in
the "SYSTEM USERS" page, the sequence will alter to initially show the "Enter
Network Password" page.