Eneo GXC-1720M - Manual (Page 89)

89
5.1.3.8 PPPoE & DDNS
Using the PPPoE
1. Install the XDSL software (obtained from your ISP dealer) in your PC.
2. Search your IP camera's IP address: you can connect the IP camera and the Video monitor.
The monitor screen will show the IP address on its right side.
3. Turn off the DHCP function (of the IP camera) if it is “ON”.
NOTE: Turn up the “DIP SWITCH” from “3” to “4”, and change the relative network settings,
the IP Address, NetMask and Gateway on the image web page (for the
IP Box camera only ).
4. Installing an IP address in your PC or notebook.
Desktop → Move the mouse focus to the Network neighborhood and click the right key of the
mouse → Choose the properties → Choose your local connection → Choose the properties
and select the configuration → Select the TCP / IP → Choose the properties → Enter the IP
address in a four-part formula, for example “192. 168. 1.101” (the first three parts must be
identical to the above numbers, only the last part can be changed to your own number, which
must never exceed 255) → Click on the mask and the mask input, namely “255. 255. 255. 0”
(a fixed formula) → Click “OK” → Click “OK”.
5. Desktop → Choose IE browser → Enter the IP camera IP address in the URL (check step #
2 above) → Enter → IP camera images will appear.
PPPoE Settings
1. Enter the IP camera home page → Choose the network → Enter “User Name: admin” and
“Password: admin” → Click “OK’.
2. Choose PPPoE → PPPoE mode: Select “ON” → Enter “Account” → Enter “Password” →
Submit → Unplug the power connection.
3. Plug in the IP camera and it will receive an IP address from the ISP dealer (this IP address
is dynamic --- every time you unplug and plug in again you’ll get a new IP address).