H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 110)

100
Figure 94 Adding rules to an SNMP view
4. Configure the parameters, as described in Table 35 .
5. Click Apply.
NOTE:
You can modify the rules of a view in the page you enter by clicking the icon of that view.
Configuring an SNMP community
1. From the navigation tree, select Device > SNMP.
2. Click the Community tab.
The Community tab appears.
Figure 95 Configuring an SNMP community
3. Click Add.
The Add SNMP Community page appears.