H3C Technologies H3C WX5500E Series Access Controllers User Manual
Page 33
23
Table 5 Login settings
Item
Access controller engine
Switching engine
Username admin
admin
Password admin
admin
Default IP address
192.168.0.100/24
192.168.0.101/24
To log in to the switching engine through HTTP:
1.
Connect the GigabitEthernet interface of the device to a PC by using a crossover Ethernet cable.
By default, all interfaces belong to VLAN 1.
The PC in this procedure is used for configuring basic device settings, and it is not necessarily the
PC you use for Web-based management.
2.
Configure an IP address for the PC and make sure the PC and device can reach each other.
For example, assign the PC an IP address 192.168.0.7 (within 192.168.0.0/24, excluding the
default IP address of the device).
3.
Open the browser, and input the login information.
a.
In the address bar, type the IP address http://192.168.0.101, and press Enter.
The login page of the Web interface (see
b.
Enter the username admin, password admin, and the verification code, and click Login.
Figure 19 Logging in to the Web interface
To log in to the switching engine from the access controller engine:
4.
Repeat the steps for logging in to the Web interface of the switching engine through HTTP.
5.
Use the oap management-ip 192.168.0.101 slot 0 command to configure the management IP
address of the OAP module in system view.
6.
Click Switch Engine on the Web interface of the access controller engine, as shown in